Upcycle a Shirt for Scrap Storage – FREE Design

July 18, 2016By Joanne BankoAppliqué, Embroidery, Projects, Upcycling 8 Comments Opinion by Paid Consultant

If you can’t bear to discard bits and pieces of fabric you are going to love our re-cycled shirt project this month. We used the Brother Free Design of the month, a miniature quilt design to decorate the front of a shirt and then turned it into a scrap bag. To further decorate the shirt we added an assortment of sewing themed appliqué designs built in to the Brother ScanNCut machine. This project is fun and easy and it’s a great way to renew and reuse a worn out shirt.

Materials

Notes:

  • We used ScanNCut2 CM650W for this project
  • Add medium weight fusible interfacing to wrong side
Figure 1
Figure 1 above

Instructions: Creating The Scrap Storage Bag

  1. Wash and press shirt. Make note of any stains or worn spots so you can cover them with appliqués
  2. Cut off sleeves and straighten sides, leaving 1-inch extra from shoulder to shoulder for hanger and seam allowance. Straighten bottom edge, leaving at least 1-inch below bottom buttonhole. Set machine for sewing with “N” foot. Sew decorative stitches along front band – see figure 1 above
  3. Cut your own shapes for appliqué or use our method with the Brother ScanNCut2 digital cutting machine. If using the ScanNCut2, prepare shapes as follows:
    • Fuse Brother Iron-On Fabric Applique Contact Sheet to the wrong side of 12-inch square of fabric and secure fabric to the standard mat
    • Select desired shapes built in to ScanNCut2 model CM650W – see figure 2
Figure 2
Figure 2
  • Create a layout in the cutting machine – see figure 3.
figure 3
figure3
  • Cut fabric pieces as directed in the ScanNCut2 manual
  • Fuse shapes to shirt and stitch them in place using various decorative stitches – see figure 4
Figure 4
Figure 4
  1. Set machine for embroidery and transfer free embroidery design, Heart 2, to machine. Add lettering as desired. Layer tear away stabilizer under pocket and embroider design on pocket using 4-inch hoop.

  • Note: This is an appliqué design. The first step stitches an outline for placement of appliqué material. The second step is for the position of the actual appliqué fabric. Place 3-inch square of fabric over the first stitched outline and then stitch second outline. Trim fabric very close to outline. Stitch the next step, the tack down and satin stitch. Stitch remaining steps – see steps in figure 5. Finish with lettering.
Figure 5
Figure 5
    1. Clean finish raw edges of shirt with an overcast stitch or a serger and sew side seams from shoulder to hem using a ¼-inch seam. Sew bottom closed using a ¼-inch seam
    2. Box each of the bottom corners as follows: Fold bottom seam and side seam so they match and form a pointed corner. Measure 2-inches from the point and sew straight from end to end

final-upcycled-shirt-for-scrap-storage

You are finished! You can drop small scraps through the neck opening. Open up the buttons to insert larger scraps or search for your saved scrap “treasures.”

Print Friendly

8 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *